12
Bore Dbbl Gun Fitting instructions
1. File the face of the grip at 90 Degrees
to the grip side as shown in fig. B using a right angle "Gunia".
2. Bend and adjust the angle of the
Gun body "Chule" to match the angle of the
stock as seen in Fig. A. The angle of the Stock at X is approximately
80°.
3. Measure the width of the stock at
X and at Y, of the gun body at S & T (Fig.A). The size
at X cannot be increased and this stock can be used in guns
having size S less than size X. The size Y can be increased
to match the size of Gun body at T by inserting a tapered
wooden or preferably metallic plate (so that it is reused)
at Y so that the stock stretches and the size increases to
match the size Y.
4. Then this stock with the insert in
place is boiled in plain water and rapidly cooled. The insert
is removed on cooling and it will be seen that the fibre sets
permanently to the new position.
5. The top cavity at AA' in Fig. B of
the stock may be shaped by the help of chisel and finished
by file for fitting the Dbbl Body. Similarly seat the lower
portion of trigger-guard in the lower cavity of the stock.
6. Fibre stock is very easy to chisel
and for fine chiseling, continuous pressure on the chisel
will cut the material, unlike in wood which has to worked
as per the grain flow.
7. During seating of the body in stock,
the fibre stock should be held in vice with a wooden insert,
so that jaws of vice do not damage the stock.
8. Drill a 8mm or 3/8" hole in
the stock at 'E' and 4mm hole FG (Fig. A) to fit screw for
holding gun body and the stock. The head of the screw will
rest at G.
HOME |
